Mending Zippers

Sewing Table areaI haven’t had a whole lot of time to sew lately and my mending pile was growing.

Jay had a couple of sweatshirts that he absolutely loves, but the zippers were no longer working. About a month ago I had ordered some longer, heavier duty zippers online and they’d been sitting around gathering dust.

 

Bad ZipperThis is what happens when a piece of molten iron lands on your zipper. Luckily it just burned through the zipper and didn’t hurt Jay at all.

I have never ever sewn a zipper in my life. I’ve always heard my mom complain about what a pain zippers are to install or replace so I had tried to avoid it. Jay LOVES this sweatshirt, though, and I can’t find one to replace it. So, ever a dutiful wife, I forged ahead.

Zipper PinnedI ripped the other one out and carefully pinned the new zipper in place. This is a heavier sweatshirt, so I had to bend a few pins before I discovered the best way to pin it.

 

Then I got the zipper foot out of my sewing machine case, put a heavy-duty needle on the machine, and got busy.

 

 

New ZipperYeah! It worked! I even managed to line the pockets up pretty good. I wasn’t too worried as this sweatshirt will be worn to work again where I’m sure Jay will be able to burn more holes in it.

After installing the zipper, I wasn’t quite finished. The same piece of iron that had burned through the zipper had also burned a hole in the right hand pocket. Jay asked if I could please patch that up.

 

 

New PocketIt’s not the prettiest patch job that I’ve ever done, but it works. Again, he’s just going to end up burning holes in it, so I didn’t stress over it too much.

 

 

 

Luckily, I had some help…

Chester the Superviosr

Chester was holding the sweatshirt down so that it wouldn’t move while I was pinning the zipper on it. She’s so helpful!

Luckily I had purchased two zippers, so when Jay handed me another sweatshirt and asked if I could replace that zipper, too, I could say yes.

Old Zipper - 2I’m not sure what happened to the zipper on this one. The teeth all looked fine, but the runner wouldn’t move. It was stuck all the way at the top.

This was the second one that I worked on and it was a little trickier. It wasn’t as heavy and the seven-year-old in China who sewed it together had me a bit flabbergasted. It looked like they had serged the zipper and the edge of the fabric together, then folded it over and ran a straight stitch up along the zipper to keep it in place.

 

New Zipper - 2This one gave me a few more problems than the first one. In fact, I had to re-pin the left side of the zipper about three different times. I finally sewed it on and zipped it up. Close enough for me!

 

Not bad for my first time working with zippers!

Advertisements
This entry was posted in Sewing and tagged . Bookmark the permalink.

One Response to Mending Zippers

  1. Pingback: Sewing A Pillow Cover | Kerry'd Away

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s